Sakura Tissue-Tek Xpress x120, Руководство по эксплуатации, Страница: 36 / 82

OPERATING INSTRUCTIONS
4.4 Revised 10/02/2012
System Warm Up
(Figure 4-E)
Figure 4-E
The WARMING UP SYSTEM cycle allows all reagents
to warm to the appropriate temperature prior to automatic
processing. Depending on the state of the system before
starting, the time required to complete the WARMING-UP
SYSTEM process may be as long as 4.5 hours. The
TIME
TO READY field in the upper right-hand corner of the
display shows the time remaining until the cycle is
complete.
During the WARMING UP SYSTEM cycle, the control
panel display changes to indicate the current status of the
cycle. Current temperatures for the retorts, Unloading
Station, and paraffin ovens are displayed, in ºC, and are
periodically updated as the cycle progresses.
Once the WARMING UP SYSTEM cycle has complet-
ed, reagents in retorts #1 and #2 are maintained at the
correct temperature until a basket or magazine set is
loaded and processing begins.
Logging On
Log on to the system before initiating processing op-
erations or accessing the UTILITIES menu. Only one user
may be logged on to the instrument at any time. It is
possible to log on to the instrument during the WARMING
UP SYSTEM cycle, or when the instrument is in the
MANUAL or AUTO START process monitor mode.
To log on to the instrument:
NOTE: If another user is current logged on to the
instrument, the
LOG OFF button is shown in the lower
right-hand corner of the screen, and the name of the user
is shown at the top of the screen. The system will not
allow logging on to the instrument until the current user
has logged off.
1.
Touch the
LOG ON button located in the lower right-
hand corner of the screen. The PASSWORD dialog
displays (Figure 4-F).
Figure 4-F
2. Use the keypad to enter the six-digit password in the
INPUT PASSWORD text box.
NOTE: If needed, use the backspace key to correct
errors when entering the password. Touch the
CANCEL
key to delete all characters from the INPUT PASSWORD
text box.
3.
When the correct password has been entered, touch
the
ENTER button to complete the log on process.
The PASSWORD dialog closes, and the previous
screen refreshes to show the user name at the top of
the screen.
NOTE: To cancel the log on process, make sure the
INPUT PASSWORD text box is empty, then touch the
ENTER key. The PASSWORD dialog will close and the
system will return to the previous screen.