6105
6105
6105
6105 Belt
Belt
Belt
Belt Feeder
Feeder
Feeder
Feeder integrator
integrator
integrator
integrator
---
---
---
--- User
User
User
User’’’’s
s
s
s Guide
Guide
Guide
Guide ---
---
---
---
7
Chapter
Chapter
Chapter
Chapter 2
2
2
2
6105
6105
6105
6105 Integrator
Integrator
Integrator
Integrator IIIInstalla
nstalla
nstalla
nstallation
tion
tion
tion
2.1
General
General
General
General
This chapter contains the information about the installation, configuration and initial programming of the
6105 belt feeder integrator. Initial programming is a machine directed procedure prompting the operator
to enter required conveyor and belt scale parameters. After all parameters have been entered, the
integrator performs an unassisted zero and span calibration.
The controller should not be installed at a place subject to severe variation environmentally. It is
preferred to be installed indoors, otherwise proper protective measures should be taken to prevent it
from exposure to direct sunlight, moisture, collision and severe mechanical vibration.
2.2
6105
6105
6105
6105 Integrator
Integrator
Integrator
Integrator Installation
Installation
Installation
Installation
The 6105 integrator must be installed indoors, not be exposed to excessive vibration, heat or moisture.
The panel mount integrator should be installed in a control panel. After installation, dustproof measures
should be taken for the front panel of the integrator and the control cabinet.
2.2.1
2.2.1
2.2.1
2.2.1
Mounting
Mounting
Mounting
Mounting
The 6105 field mount feeder controller can be vertically secured to the rigid and flat wall through the 4
mounting holes at the back of the enclosure. Care should be taken to insure the mounting surface is flat
so as not to twist or warp the fiberglass enclosure when tightening the mounting holes.
The 6105 panel mount integrator should have a clearance of at least 5cm at the top and bottom to allow
air circulation. In case that the integrator must be positioned under the heat sources, proper space
around the integrator should be reserved. Sufficient space should be kept behind the integrator to
facilitate wiring and changing fuse. The side clearance should be easy for securing the holding brackets
after the 6105 has been put in place. Disconnect power supply from the integrator when mounting the
bracket. From the back, insert the holding brackets on both sides of the integrator firstly, then screw
down tightly to secure the integrator and prevent dust ingress.
2.2.2
2.2.2
2.2.2
2.2.2
Safety
Safety
Safety
Safety Precautions
Precautions
Precautions
Precautions
Do not install, operate, or perform any maintenance procedures until you have read the safety
precautions which follow.
1. Do not connect power to the electronics or turn on the unit until you have read and understood this
entire manual. The precautions and procedures presented in this manual must be followed carefully
in order to prevent equipment damage and protect the operator from possible injury.
2. CAUTION
Hands and clothing must be kept away from all moving or rotating parts.
3. WARNING
Covers over the electronics should always remain in place during operation. They should be
