Saimo 6105, Инструкция по установке, эксплуатации и обслуживанию, Страница: 24 / 72

6105
6105 6105
6105 Belt
Belt Belt
Belt Feeder
Feeder Feeder
Feeder integrator
integrator integrator
integrator ---
--- ---
--- User
User User
User’’’’s
s s
s Guide
Guide Guide
Guide ---
--- ---
---
19
Note: When Dual channels are used for the weight channel, the two load cells should be connected to
the channel 1 and channel 2 separately on the A/D board.
5.3.1.6
5.3.1.6 5.3.1.6
5.3.1.6 Initial
Initial Initial
Initial Setup
Setup Setup
Setup 6
6 6
6
Press “PAGE DOWN” soft key from the Initial Setup 5 Menu described in Section 5.3.1.5, the sixth page
of Initial Setup Menu is displayed as follows:
Note: the setting value of the speed mode is “Simulated” and “Actual”. When “Simulated” is selected,
the integrator will generate an analog signal for speed input. In case that “Actual” is selected, the speed
input is an actual speed signal. Simulation allows operation without a speed sensor.
There are two channels for selection: Channel 1 and Channel 2.
5.3.1.7 5.3.1.7 5.3.1.7 5.3.1.7 Establishing Establishing Establishing Establishing Test Test Test Test Duration Duration Duration Duration
Press “PAGE DOWN” soft key from the Initial Setup 6 Menu, the first page for establishing test duration
appears.
2006-3-21 12:00:00 Scale#1
8000000
t
888 t/h
1m/s
Establish test duration!
AUTO MANL PAGE
DURA DURA UP
2006-3-21 12:00:00 Scale#1
INITIAL SETUP 6
Speed Mode: [ SIMULATE ]
Speed Channel: [CHANNEL 1]
Press
↑
or
↓
key, then press ENT!
MAIN PAGE PAGE
MENU DOWN UP