This document and all copies are the property of Spider
®
. All dimensions and data are indicative only.
The user must ensure that the equipment complies with local rules and regulations.
Document No: 721641-1
Revision: A
Issue Date: 2017-Dec-18
Page 33 of 38
= Inspect
= Verify
= Perform process
Problem
Possible Cause and Solution
d) h
oiSt
h
UmS
, S
tartS
S
loWly
and
iS
S
lUggiSh
and
YELLOW
v
oltage
i
ndicator
l
ight
iS
on
Check run voltage. If not correct (see “Operating range”
on Page 15in section 4a), do any or all of the following:
►
Run separate power supply cords for each hoist.
►
Use shorter power supply cords.
►
Use short power supply cord with larger wires.
►
Add a booster transformer at the power source.
Problem
Possible Cause and Solution
e) W
ire
r
oPe
Will
not
r
eeve
Increase hand pressure on the wire rope while pressing the
↑UP control button.
Take the wire rope out, rotate it 180
°
and put it back into the
hoist while pressing the ↑UP control button.
Poor bullet: prepare new end. Refer to the wire rope
section in Section 3a.
End of wire rope is bent or kinked: prepare new end.
Dirt or other material is obstructing the rope inside the
hoist.
f) m
otor
rUnS
n
ormally
,
bUt
h
oiSt
Will
not
r
aiSe
l
oad
Make sure the bullet end of the wire rope has come out of the
wire rope exit guide.
Inspect the wire rope for damage or wear. Replace if
necessary.
WARNING!
WIRE ROPE MAY BE JAMMED.
DO NOT
OPERATE HOIST. CALL YOUR SUPERVISOR.
