continued on next page
70
Installing Harness System
69
Insert Buckle’s Metal Retainer
into Slot Closest to Child
Buckle
must
face out.
Rear-Facing Mode
: You
must
use
the 1st or 2nd buckle slots.
Forward-Facing Mode
: Any slot
can be used.
Fully Recline the Child
Restraint
Pull out on recline handle and
push top of child restraint back.
Check Buckle
Pull up on buckle to make sure it
is secured.
The buckle
must
not pull out.
Reach Under Seat Between
Base and Shell and Through
Recline Handle
Pull metal retainer completely
through pad and shell.
1
3
1
2
3
2
4
Undo Fasteners on Seat Pad
and Pull Headrest Pad Off
Bottom of Headrest
Unthread harness straps from
slots on side of headrest. Loosen
harness straps.
Pull chest clip, harness straps,
and buckle tongues out from
behind the headrest and seat
pad.
Pull headrest pad down around
bottom of headrest.
Slide harness straps into slots in
headrest pad.
Attach seat pad fasteners.
1
Thread Buckle and Chest
Clip
Harness strap ends go through
the
back
of buckle tongues and
through the chest clip
front to
back
as shown.
6
If you have removed the harness straps from the splitter
plate, and the buckle tongues and chest clip have been
unthreaded from the harness straps, follow the steps
below to rethread them.
5
Adjust Headrest to
Highest Position
