Rear-Facing Mode
32
31
Adjusting Tether Strap
To tighten:
After the child
restraint is locked into place
with the lower anchor/UAS belt
or vehicle belt, push down on
child restraint and gently pull
on free end of tether strap.
To loosen:
Lift up on tether
adjuster and push it towards
tether hook.
Pull free end of
belt to tighten
Lift adjuster up
to loosen
Storing Tether Strap
When installing rear-facing,
using the booster seat mode,
or when the car seat is not
installed in a vehicle
, attach
the tether hook to its storage
attachment on back of car seat
as shown.
Gently tighten to remove slack.
Adjuster
Strap
Hook
Storage
Location
Tether Storage
and Parts
Never install a rear-facing child restraint in the
front seat of a vehicle equipped with an active
frontal airbag.
Do not use the tether for rear-facing mode.
Secure tether strap to its storage location.
Do not use the UAS belt along with the vehicle lap
or lap/shoulder belt.
Check the vehicle belt or the UAS belt before each
use. Use only if the belt can be tightened properly
and locked securely in place.
Do not fasten multiple UAS connectors on the same UAS anchor
bar in the vehicle.
The anti-rebound bar must be used in rear-facing mode.
Even when unoccupied, this child restraint must be fi rmly secured
to the vehicle with a UAS belt or with the vehicle seat belt.
This child restraint MUST always face the rear of the vehicle until
the child is at least 1 year old and weighs 10 kg (22 lb).
Failure to follow these warnings can result in serious injury
or death.
2.3-18 kg
(5-40 lb)
and
48-102 cm
(19-40 in.)
Lap/Shoulder
Belt
Lap Belt
UAS Belt
