SafeHome WS200X, Руководство пользователя, Страница: 33 / 106

www.safehome.dk www.safehome.dk 20
21
4.3 Remote Control
4.3.1 Introduction of Remote Control
The remote can be used to arm, disarm, and activate the siren instantly if required (using
the Panic function). It allows user to operate the system remotely, from inside or outside
the property.
ARM – Pressing the ARM button on the remote will arm the system, triggering the preset
exit delay. When triggered the Smart Panel’s LED light will flash Red and indicate the
triggered zone.
DISARM – Pressing the DISARM button on the remote will
disarm the system instantly and the system will return to
STANDBY mode.
ALERT – Pressing the ALERT button on the remote will put
the system into Alert mode and a chime will sound if any
of the sensors are triggered. The Green light on the Smart
Panel LED display will flash and indicate the triggered zone.
HOME – Pressing the HOME button on the remote will set
the system in HOME mode which will operate the system in
both ARM and ALERT modes in different preset zones.
PANIC – If the HOME and ALERT buttons are pressed together the systems
alarm is immediately activated
4.3.2 Operation
4.3.2.1 Powering up the Remote Control
The Remote Control includes a 12 V alkaline battery. To activate, unscrew and remove
the back of the Remote Control, and carefully remove the clear plastic insulation tab from
the battery. If the battery is dislodged, replace it noting the correct polarity as shown
inside the battery compartment. Replace the battery cover.
4.3.2.2 Enrolling the Remote Control onto the Smart Panel
Note: Before being able to use the Remote Control supplied with the system, or any
additional Remote Controls, they first need to be enrolled (added onto the system) as
follows:
Step Keys Description Note
1
PIN +
You must be in
READY mode
before
programming To make sure you are in READY
mode:
Enter your PIN
Press
, the symbol disap-
pears from the screen.
2
+
Press the buttons
on control panel to
enroll the remote
controls into the
system.
Then press any but-
ton on the remote
to register and get
an ID number on
remote control. LCD display flashes the ID no. of
the remote to be enrolled e.g. when
enrolling the first remote ID no. “01”
will flash. Once the first remote is
enrolled the “02” will flash ready
for a second remote to be enrolled
(One beep indicates that the remote
was enrolled to the Smart Panel
successfully)
Note: It is recommended that the
ID No. is marked on the remote in
case it needs to be deleted at a later
stage.
Note: when pressing any button on
the remote, ensure that the distance
between the panel and the remote
is at least ½ meter.
3 Complete the set-
ting After the setting is completed, return
the Smart Panel to READY for mode
selection.