Spiral
®
SST and STT Prewire Installation Manual
Spiral
®
SST and STT Prewire Installation Manual
■
1072124-0
■
Rev 03
■
01/22
17
12
Adjust
the strap until the measured
distance matches the object list and the
distance from the clamp to the bracket is
two inches (2”).
13
Remove
the nuts and
retrieve
the third
clamp plate.
Loop
the spring strap down between the
second and third clamp plate.
Tighten
the nuts to secure the strap.
If necessary,
trim
excess strap length.
14
Release
each spring from the baseplate
tube.
Lift
each spring and
slide
the spring tab
into the slot in the spring bracket.
15
Stretch
the springs downward.
Slide
the bottom spring tabs into the wide
slot
a
, through the narrow
b
, then
pull up
to lock
it into the retaining slot
c
.
How to install a second assembly in the
side column
1
Install
the guide tubes into the second
bracket.
Install
the second bracket above the
first bracket.
2
Follow
steps 4-15 for installing the springs.
Make sure
the spring bracket bumpers face
out, toward the first spring assembly.
13mm
2"
c
a
b
01260110
01901506
2
SMALL PARTS
10mm
How to install the locking collars at the top and bottom of the springs
Install
the locking collars onto the tabs at the top
and bottom of each spring after the secondary
drive belts have been tensioned.
1
Install
collar into the top tab:
a
Slide
the opening
in the collar onto
the tab.
b
Twist, then push
the collar across
the tab (the collar is
flexible and will
bend open enough
to fit).
c
Push
the short end
around until it
clicks into place.
2
Follow the same
steps
for the tab
at the baseplate
pulley assembly.
1071781
2
per spring
SMALL PARTS
snap!
a
b
c
a
b
c
snap!
snap!
