16
©
Rear View Safety
SENSOR INSTALLATION GUIDELINES
• Carefully drill a 25mm hole and insert the Rubber Jacket, properly orientated
“UP”, in the hole first. Then insert the Sensor, again properly orientated “UP.”
• Depending on the thickness and construction of the bumper, the hole diameter
may need to be varied. The Rubber Jacket is designed to seat properly into a
25mm hole with a 1/8 inch (3.2mm) thick metal bumper. If this is not the case, the
flanges on the Rubber Jacket must be taken into consideration. It is suggested
that a test hole be utilized to confirm a proper fit.
• Each Sensor detects objects in a circular area approximately 20” in diameter.
It is recommended that the face of all Sensors should be on the same plane to
ensure the accuracy of the system.