12
©
Rear View Safety
REAR CAMERA INSTALLATION - STEP VAN
The backup camera will mount above the rear door, in the center if possible, but
may need to be offset due to the location of existing running lights. If this is the
case, mount between the center light and either left or right center light. Make
sure the camera does not block any of the existing lights.
Note: Always avoid mounting the camera above a light to avoid the light washing
out the camera’s view.
•
Use 10-24 x 1” machine screws, nylon insert lock nuts and washers to secure
the bracket to the van body.
•
Drill a 3/4” hole above or below the bracket for the cable and grommet.
•
Brush primer around the grommet hole and allow to dry.
•
Insert the rubber grommet that is on the camera cable into the opening, making
sure that it is seated properly.
•
Use thread locker on the screws that secure the camera to the mounting
bracket. Do Not tighten completely until the system is powered up.
•
Once the system is powered up, you will need to adjust the angle of the camera.
•
Adjust so you can see the edge of the bumper.
•
Adjust the sun shield so it shades the camera as much as possible without
blocking any of the view.