Rear View Safety, 1797 Atlantic Ave., Brooklyn NY 11233
800.764.1028 [email protected]
11
SIDE CAMERAS – STEP VAN
Flush Mounting – All Step Vans
Note: All step vans should have access on the backside of the fender for flush
mounting. Always double check on both sides to verify before drilling any holes.
Be sure to check both sides for air vent. Mount the camera below the air vent. If
there is no vent on the passenger side, mount the camera at the same height as
the driver’s side camera.
The location and angle of the camera will need to be set before drilling the holes.
Once determined, you can use the foam tape to mark the hole locations.
•
Check angle with the flat lens portion of the camera. “Level” apps are available
for smart phones.
•
The camera will be mounted to the fender with 3mm Metric (or #4 SAE) machine
screws, nuts and washers. This will require 9/64” holes.
•
The camera cable will require a 3/4” hole. Use the foam sealing tape to mark
the cable hole.
•
Check to make sure the drilled holes line up before peeling the truck side of the
tape
•
Attach the camera with the supplied 3mm machine screws, nuts, and washers.