RG-SS6510
-
4C Series Switch Hardware Installation and Reference Guide
Product Installation
- 26 -
Withdraw the fan module uprightly and slowly.
Install a blank panel to the empty slot to prevent dust from entering the switch.
3.6 Installing and Removing an Extension Module
S6510-4C series module are not hot swappable. Please make sure to power off the switch before installing or
removing extension modules.
Wear anti-static gloves before the following operations.
Installing an Extension Module
Step 1. Take off the blank panel of the extension module.
Step 2. Pinch the captive screws on M6500 and rotate the ejector lever outward. Align M6500 to the guide rail of the
extension module, and push it along the rail horizontally and slowly.
Step 3. Tighten the captive screws with a screwdriver to secure M6500 in the chassis.
Figure 3-1 Installing an Extension Module
Insert the extension module smoothly and do not insert the module upside down.
Do not hold the PCB or touch the components on the PCB.
If it is difficult or even impossible to insert the module, make sure the extension module and guide rail are well
aligned, and then insert the module again.
If the screws cannot be tightened, it is probably because the extension module is not fully inserted. Please check
that carefully.
