RG-SS6510
-
4C Series Switch Hardware Installation and Reference Guide
Product Installation
- 22 -
The related network cables have already been deployed at the installation location.
3.3 Cabinet Installation
Precautions
When you install the cabinet, pay attention to the following requirements:
All expansion bolts for fastening the cabinet base to the ground should be installed and tightened in sequence
from bottom up (large plain washer, spring washer, and nut), and the installation holes on the base and the
expansion bolts should be well aligned.
After the cabinet is installed, it should be stable and still.
After the cabinet is installed, it should be vertical to the ground.
When multiple cabinets are placed side by side in the room, they should be aligned in a straight line, with an error
less than 5 mm.
The front/back doors of the cabinet should be properly installed. You can open and close them smoothly. The
locks should work normally, and all keys should be complete.
There should be no unnecessary and informal labels inside the cabinet and on various boards.
Blank panels should be installed completely.
Fastening screws of various devices in the cabinet of the same model should be ready and tightened.
Various boards of the equipment should be installed securely, and the fastening screws on the panel should be
tightened.
All wiring inlets at the top and bottom of the cabinet should be installed with rodent-resistant nets with seams no
more than 1.5 cm in diameter, to prevent rodents and other small animals from entering the cabinet.
Antistatic wrist straps should be provided in the cabinet.
Installation Steps
1)
Plan the available space before installing the cabinet. You must reserve sufficient space for front and back doors
for maintenance.
2)
Mount and fasten the cabinet at the designed location as planned.
3)
Install the appropriate chute and cables.
4)
Install the tray and wiring layer on the rack according to the configuration of one rack with one cabinet installed or
one rack with multiple cabinets installed.
3.4 Mounting Switch into the Cabinet
Precautions
Before mounting RG-S6510-4C into the cabinet, first verify that the front and back brackets of the cabinet are at the
right locations. If the bracket is too far forward, the front panel of the equipment may be too close to the front door, so
that the front door cannot be closed when the equipment is connected with network cables and pigtail fibers. Usually,
