Rugby Manufacturing 1841488C | 13-Jul-20 Page 9
Rugby Manufacturing SR-Series Hoist Manual
Hoist & Sub-frame Installation cont.
2.
Locate the ideal mounting angle location along the chassis frame while keeping within the
guidelines shown in (
Figure 10
). Ensure that the weld from the subframe to the mounting
angle will be positioned directly below the saddle tube.
NOTE: Optional 10ga rivet spacers may be positioned under the mounting angle and the rear hinge angle
to clear rivets on the truck frame.
Welding, oxy-fuel cutting, or grinding sparks can cause fuel to ignite
which in turn can lead to injury or death. Always take adequate steps to
avoid ignition of fuel from fuel tanks when welding, grinding, or oxy-
fuel cutting during equipment installation.
Heat from the truck’s exhaust system can cause hydraulic component
failure and may lead to a fire which could cause injury or death. Always
install equipment in locations where heat from the exhaust system will
not damage any hydraulic components.
Figure 10
