Operation
Rugby Manufacturing 1841488C | 13-Jul-20 Page 16
101010P1010101101010
Rugby Manufacturing SR-Series Hoist Manual
Body Prop Operation
1.
Raise unloaded body to sufficient height and shut off all power.
2.
While positioning yourself as far as possible from underneath the truck, grasp prop from
latched position.
3.
Rotate prop upwards to vertical position.
4.
Push down until the prop locks in vertical position.
5.
To lower the body prop for operation of truck, “reverse” the above procedure.
The body prop is only to be used to prop an unloaded body. Seri-ous
injury or death can occur if the body prop is misused.
Maintenance
Grease all hoist and rear hinge grease fittings every 100 cycles or every two months. Some grease
fittings are in hard to find locations - Refer to
Figure 15
for all grease fitting locations.
Check hardware regularly and retighten as needed. Refer to
Figure 3
for torque guidelines.
Check hydraulic components regularly for any leaks or signs of wear. Replace damaged or leaking
components as needed. Refer to the pump or hydraulic components installation and operation
manual for more service information.
