Ruckus Wireless ZoneFlex 7762, Руководство по установке

Страница: 24 / 56

20
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
NOTE: Make sure that you configure the Local Area Connection properties, not the
Wireless Network Connection properties.
3. When the Local Area Connection Properties dialog box appears, select Internet
Protocol (TCP/IP) from the scrolling list, and then click Properties . The Internet
Protocol (TCP/IP) Properties dialog box appears.
4. Write down all of the currently active network settings. You will need this information
later when you restore your computer to its current network configuration.
5. Click Use the following IP address , and then configure the IP address settings with
the values listed in Table 3 . For a sample configuration, refer to Figure 11 .
You can leave the Alternate DNS server box blank.
6. Click OK to save your changes and close the TCP/IP Properties dialog box.
7. Click OK again to close the Local Area Connection Properties dialog box.
Windows saves the IP address settings that you have configured.
Table 3. Configure your computer’s IP address settings
IP address
192.168.0.22
(or any address in the 192.168.0.x
network – with the exception of
192.168.0.1
, which
is already used by the AP)
Subnet mask
255.255.255.0
Default gateway
192.168.0.1
Preferred DNS server
192.168.0.1