Ruckus Wireless ZF7761CM, Руководство по установке

Страница: 45 / 52

41
Resetting the Access Point to Factory Default Settings
Using SNMP to Reset the Access Point
Figure 22. Pinout connections for the DC connector
Using SNMP to Reset the Access Point
You can use SNMP on either the access point or cable modem to reset the AP to factory
default settings. The procedure is the same, regardless whether you perform this operation
from the AP or CM.
CAUTION:
Performing this procedure resets only the AP component to its factory default
settings. If you want to reset both the CM and AP components to factory default settings,
perform the procedure described in
“Using the Reset Switch on the DC Power Supply”
on page 40 instead.
Before You Begin
Before starting this procedure, you must first obtain the following:
■
The IP address that is assigned to the access point that you want to reset to factory
default settings. You can obtain this information from the DHCP server on the network.
■
Obtain the related MIBs from Ruckus Wireless. Contact your authorized Ruckus
Wireless sales representative or Ruckus Wireless Support. For the Ruckus Wireless
Support contact information, visit the following Web address:
http://support.ruckuswireless.com/contacts
To reset the access point to factory defaults using SNMP
1. Connect the administrative computer to the same network as the access point.
2. Start your MIB browser.
3. Load the Ruckus Wireless MIBs onto the MIB browser.
No. Pinout
1 +DC power
2 -DC power
3 Factory reset
4 Ground
1
4
2
3