RS COMPACT FREEZE TUNNEL, Руководство по эксплуатации и обслуживанию

Страница: 31 / 46

OPERATION & MAINTENANCE MANUAL
CompactFreezer
29
which is just inside the freezer walls, should not be subjected to this temperature.
4. Do not use scouring powder or any other abrasive cleaner that would dull the finish of the
fiberglass inner and outer walls of the freezer.
5. Hose down the interior of the freezer with the conveyor running. Give particular attention to the
sills under the conveyor belt where the modules join and along the door gasket strips.
6. The moving conveyor belt can be scrubbed and hosed down at the exit or entry end.
7. The design of the freezer allows wash water to drain out of the freezer freely.
8. To assist in drying out the inside of the freezer and to blow clinging water from the conveyor
belt, close all doors and run the conveyor and fan for about 1/2 hour.
9. It is best to start a production shift with the freezer as dry as possible. It is recommended that
with all power off, both the upper and lower doors be left open until the next production shift.
10. Any removable parts that were taken off the freezer for clean‐up should be replaced; such as
stainless steel panels at the ends of the freezer, exhaust duct cleanout cap, exit and entry
curtain, etc.
11. The fiberglass walls of the freezer can be polished periodically. Contact RS Cryo for additional
information.
9. Maintenance
This section provides information for corrective and preventive maintenance of the various subsystems
of the
Cabinet Freezer For maintenance of specific more specific information, the appendices and other
sections should be consulted. For more specific information about the equipment components, please
refer to the manufacturers’ literature in Appendix C – Component Manuals .
Care should be taken when performing maintenance on the freezer. The following safety considerations
are listed to protect you from injury:
•
Maintenance should only be performed by qualified personnel.