RS COMPACT FREEZE TUNNEL, Руководство по эксплуатации и обслуживанию

Страница: 14 / 46

OPERATION & MAINTENANCE MANUAL
CompactFreezer
12
4. Installation & Assembly
4.1. SITE SELECTION REQUIREMENTS
The installation site of the Compact Freezer must meet the following requirements for safe operation:
•
Located in close proximity to the Liquid Nitrogen (LN
2
) tank or vessel.
•
Supply Voltage/Frequency: 120 VAC+ Ground, 1 phase, 60Hz
•
Located in a large, well ventilated room
•
The exhaust duct piping from the ULTRA‐FREEZE® must run outside in order to ensure removal
of the N
2
gas from the processing room. Note: Avoid exhausting to outside areas where people
typically congregate (e.g. break areas, smoke areas, etc)
•
Rooms underneath the installation site must be adequately ventilated.
•
Warning or hazard signs are posted around the freezer for safety purposes are highly
recommended.
Installation Path Requirements
To avoid possible hindrances, carefully map out the path to the installation area prior to unloading the
Compact Freezer from the truck. Determine the most suitable freezer orientation to pass through all
"bottle necks" and to assure correct orientation at final in ‐ plant location.
Pay particular attention to:
•
the height and width of doorways on the path to the installation area;
•
the height and width of the various corridors.
Be sure to account for obstructions such as light armatures, ramps, overhangs, ducting, cupboards,
shelves, etc. Use the dimensions provided in
Section 3.1 ‐ Equipment Specifications .
Floor Space Requirements
Prior to installation of the Compact Freezer ensure that the space available at the installation site will
accommodate the freezer dimensions.
Remember to:
•
allow for sufficient space around the freezer for normal traffic;
•
make sure the freezer is accessible in case of emergency;
•
provide sufficient clearance for all pivoting parts (e.g. doors). Be sure to account for
obstructions such as light armatures, ramps, overhangs, ducting, cupboards, shelves, etc.