RS COMPACT FREEZE TUNNEL, Руководство по эксплуатации и обслуживанию

Страница: 33 / 46

OPERATION & MAINTENANCE MANUAL
CompactFreezer
31
c. Adjust the tensioning devices to center position
d. Pull the conveyor belt tight through the freezer and determine which drive links cut to
shorten the belt. See Figure 1 in Appendix A.
e. After cutting out the links, pull the belt ends together and join together with the splice rod;
being sure to thread all mesh properly. The threaded end should be on the side that would
cause the nut to rotate clockwise should the bottom of the nut ride up the top of the belt
supports which would prevent the nut from unscrewing itself.
f. Run the nut on the splice rod and peen it on securely.
g. Adjust the tensioning devices. Remember the conveyor belt will shrink and become shorter
when cooled to an operating temperature in the minus degrees, so check operation of belt
under cold operating conditions.
Conveyor Drive Gear Reducer
Change oil after every 1,000 hours of operation. Use Mobil 600W cylinder oil or equivalent.
9.3. SAFETY RELIEF VALVES
Safety Relief Valves should be located between any two shutoff valves, and changed every 5 years or
upon any signs of leakage for preventative maintenance.
9.4. MODULE JOINTS
Remove and replace silicone as needed, or when a sanitation issue becomes present. Replace module
joint tape when cracked or peeling.
9.5. SOLENOID VALVES
Open each LN2 in feed line shut ‐ off valve to check the solenoid valves; turn the power on to all fans and
instrument power. Adjust the temperature controller so that Alarm 1 light is off (should be low
pressure injection). Adjust the temperature so the Output 1 and the Alarm 1 light are on (should be
high pressure injecting).
When malfunctioning solenoid valve is located and confirmed, check wiring connections and solenoid
coil and correct as necessary. Solenoid valves should be replaced every 2
‐ 3 years as part of preventative
maintenance.
9.6. STRAINER