Royal Enfield CONTINENTAL GT 650 TWIN 2018, Руководство по обучению обслуживанию

Страница: 131 / 198

ROYAL ENFIELD 650 TWIN SERVICE TRAINING MANUAL
130
15. ROLL OVER SENSOR
Roll over sensor is also known as bank angle sensor.
This sensor gives signal to the ECU if the vehicle rolls
off during any mishap or accident. The ECU then cuts
off the supply to the fuel injector and the spark plug
thus stalling the vehicle, due to which further major
mishap is avoided.
It is mounted under the seat on the vehicle above
battery box as shown in photo.
Specifications (Across pins 225 & 114)
Voltage when vehicle is upright 0.36 to 1.5 V
Voltage during a fall
3.75 to 4.35V
Banking Angle 75 + 10
o
cutoff
Operating Temperature -20
o
C to + 85
o
C
14. GEAR POSITION SENSOR
Gear Position Sensor indicates the ECU, the gear in
which the vehicle is operated at that instant. The input
is also required for drive ability calculations in the ECU.
During neutral gear position a light will glow in
instrument cluster.
Operating temperature -20
o
C to +150
o
C
Specification (Across pins 123 & 208)
Neutral Gear 0.37 to 1.16V
1st Gear 1.22 to 1.50V
2nd Gear 4.30 to 4.80V
3rd Gear 3.63 to 4.12V
4th Gear 2.98 to 3.45V
5th Gear 2.30 to 2.80V
6th Gear 1.68 to 2.10V
13. SIDE STAND SWITCH
Side stand switch prevents the vehicle from starting
when the side stand is down and not in neutral gear.
It is HALL - IC type switch, which is directly conneted to
ECU.
Specifications (Across pins 226 & 208)
Side stand down 2.80 to 4.05 V
Side stand up 0.35 to 1.15 V
Side stand switch
actuator
Roll over sensor
The clutch switch gives digital input to the ECU i. e.,
0 or 1 which will help in starting of the vehicle when
the engine is not in neutral gear.
It is mounted under the LH switch module at handle
bar.
1 – Dummy, 2 – B
3 – GRw, 4 – R/L
1 – R/L , 2 – B, 3 – G
GPS Coupler
+ve Supply
Ground
WG Signal
1 – R/L, 2 – B, 3 – B/Y
Coupler
Mounting
Torque 6.9 Nm