Royal Enfield CONTINENTAL GT 650 TWIN 2018, Руководство по обучению обслуживанию

Страница: 111 / 198

ROYAL ENFIELD 650 TWIN SERVICE TRAINING MANUAL
110
Fastener, Size, Tool Usage, Precautions, Photos Aggregate to Assemble Instructions
22. Clutch

Ensure collar on bush is facing inward and
then assemble it on countershaft. Ensure
it is seated properly.

Assemble needle bearing (a) on
countershaft (b) .

Assemble clutch housing (outer comp.
clutch) (a) on Countershaft and ensure
the slots (b) are facing outside.

Assemble thrust plate thick washer on
Countershaft.

Assemble center clutch assembly (a) into
Countershaft.

Assemble Belleville washer and Nut M17
clutch sleeve hub tighten to specified
torque.
Assembly Sequence

Install Seat Judder and Spring Judder on
Center Clutch.

Install the Disk clutch Friction plates and
Clutch plates as shown in exploded view.

Install Plate Comp Clutch Pressure on
Stack (Ball Bearing & Seat Spring are
already assembled in Plate Comp).

Install Spring Clutch in Plate Comp Clutch
Pressure [Use 3 leg Alignment Jig].

Install Plate Stopper on Spring Clutch &
tighten qty. 3 nos. flanged hex bolts
(M6x35) equally to torque 8 to 12 Nm.
NOTE
For tightening
/ loosening of
clutch lock
nut use hub
holding
special tool
Clutch hub holding
special tool
Part No. ST-30266/A
Torque 100 to
120 Nm
27 mm Socket
with Torque
wrench