S2
USER MANUAL
13
When the satellite is correctly found, the meter will start the buzzer (check item 8.4
ANTENNA POINTING AID TONE: BUZZER at page 16). The Noise Margin value
(also displayed on a level bar with peak level) and the Quality Test results will be
displayed on the screen:
With the help of the buzzer sound and maximizing the lenght of the bar, proceed to
fine align the dish.
To fine align the dish on the two polarizations (“cross-pol”), press and release the
MEAS [G] key. The transponder currently under measurement will be highlighted (“A”
polarization). Using the UP [H] and DOWN [L] keys, select a transponder with a
different polarization (“B” polarization) and just repeat the dish fine alignment on this
last transponder.
To confirm the alignment, just check that a trasponder with “A” polarization is
correctly received.
8.2 “DUAL FEED” DISH ALIGNMENT
This meter allows the alignment of Dual LNB satellite dishes by performing
simultaneous measurements on both LNB, with no need to continuously switch
between RF cables and to set different frequencies.
~
PREPARING TO ALIGNEMENT: SWITCH DiSEqC
Both cables from the two LNB must be connected to the meter via a DiSEqC
switch; this switch is provided with the meter.
~
DISH ALIGNMENT AND MEASUREMENTS
Press and hold for 2” the SAT FINDER
[E] key to show the following
screen:
Содержание S2 SCOUT
Страница 42: ...S2 USER MANUAL 42 NOTE...
Страница 43: ...S2 USER MANUAL 43 NOTE...