Rover S2 SCOUT, Руководство пользователя

Страница: 32 / 44

S2
USER MANUAL
32
To add more transponder to the current Memory plan, just press the SELECT [M]
key to highlight, the signal type to store (in the display second row) and then just
repeat the sequence of the operations above mentioned.
To quit this function, press and release the MEAS [G] key.
~
ADD A NEW TRANSPONDER TO AN EXISTING MEMORY PLAN
Press repeatedly the SELECT [M] key to highlight the top-left field on the display
(MANU 1, MANU 2, …).
Press either the UP [H] or the DOWN [L] key to select the desired memory plan. In
the display first row, next to the highlighted Memory Plan (MANU 1, MANU 2, …)
the first blank position in the Memory Plan will appear (PR .. )
Should you need to add the transponder to the selected Memory Plan, go and
proceed as described in next point 13.2 ADD A SELECTED TRASPONDER TO A
EXISTING USER DEFINED MEMORY PLAN.
To replace a transponder previously stored in the current target memory plan:
•
Press the SELECT [M] key to highlight the field of the Memory position (PR ..).
•
Press either the UP [H] or the DOWN [L] key to select the transponder to be
replaced.
•
Press repeatedly the SELECT [M] key to highlight the signal type to be stored
in the display second row (analogue, digital DVB-S, digital DSS) and select the
desired signal by pressing either the UP [H] or the DOWN [L] key.
•
Press repeatedly the SELECT [M] key to highlight the high/low band and
polarization (LNB), DiSEqC, local Oscillator (L.O.) e Symbol rate (SR). Press
either the UP [H] or the DOWN [L] key to change the value of each of these
variables.
•
Press repeatedly the SELECT [M] key to highlight the area of the frequency
value in the top-right corner of the display and then set the desired value by
pressing either the UP [H] or the DOWN [L] key. To quickly change the
frequency, just keep pressed either the UP [H] or DOWN [L] key up to reach
the desired frequency.
•
Press the SELECT [M] key to highlight either STORE? or OVERWRITE? (to
replace the selected transponder).
•
Press the UP [H] key. to store the transponder.
To add and/or replace further transponder to the current Memory Plan press the
SELECT [M] key to highlight the memory position item (PR..) on the display top
row, next to the current Memory Plan (PLAN 1, PLAN 2, …) and proceed as above
described.
To quit this function, press and release the MEAS [G] key.
13.2 ADD A SELECTED TRASPONDER TO A EXISTING USER
DEFINED MEMORY PLAN
Tune a transponder (digital or analogue, check chapter 9.2 MANUALLY TUNING
THE TRANSPONDER (BY KNOWING ALL THE DISTINCTIVE PARAMETERS) at
page 18).