Programming Cards and Tags
CP-R25 Hardware & Software Manual
Page 24
6. From
the
Transmit Format
dropdown menu, select the
applicable transmission format.
7. Define
the
Led and Buzzer Control
behavior, check /
uncheck the
Enable Led
and
Enable Buzzer
select boxes.
8. To
Enable
the
Lockout
feature, check the
Enable
checkbox
and define the lockout behavior using the
Attempts
and
Duration
fields.
9. For reports on operational failures, check the
Failed
operation reporting
Enable
checkbox.
10. Enter the KeyA to be used by the reader as the unique
KeyA for the organization or site. Type the same value in
the
Reader KeyA
and the
Confirm Reader KeyA
fields.
Note:
The KeyA number is hidden by "*" characters, so write down
the new key and keep it in a safe place to avoid exposing
this secret key to unauthorized personnel. The KeyA value is
entered as a 12 hexadecimal digit with the format
FFFFFFFFFFFF.
11. Place a blank MIFARE card or a card previously configured
as a Configuration Card on the CP-R25 Desktop
Programmer antenna area.
12. Click
Start
to begin programming the MIFARE card.
On completion a message is displayed in the Message Log
area to verify that the programming succeeded.
If the programming is a failure there is a short buzz and the
swipe Card Reader LEDs lights red for three seconds.
5.4
Programming User Cards or Tags
In this section both cards and tags are referred to as cards. The
card configuration type depends on what level of system
security is implemented. The cards configuration depends on
the reader type used. There are two reader types which
determine what tab to use when configuring the cards.
•
Sector reader – Used to configure and read sector reader
cards. This tab allows configuration of both User ID/Card
Содержание Mifare CP-R25
Страница 2: ......
Страница 41: ...Maintenance CP R25 Hardware Software Manual Page 40 ...
Страница 51: ......
Страница 52: ...0706 0960349 00 www rosslaresecurity com ...