Rosslare Mifare CP-R25, Руководство по аппаратному и программному обеспечению

Страница: 24 / 52

Programming Cards and Tags
CP-R25 Hardware & Software Manual Page 23
keypads’ transmission format from the Transmit Format
dropdown menu.
9. Enter the KeyA to be used by the reader as the unique
KeyA for the organization or site. Type the same value in
the Reader KeyA and the Confirm Reader KeyA fields.
Note:
The KeyA number is hidden by "*" characters, so write down
the new key and keep it in a safe place to avoid exposing
this secret key to unauthorized personnel. The KeyA value is
entered as a 12 hexadecimal digit with the format
FFFFFFFFFFFF.
10. Place a blank MIFARE card or a card previously configured
as a Configuration Card on the CP-R25 Desktop
Programmer antenna area.
11. Click Start to begin programming the MIFARE card.
On completion a message is displayed in the Message Log
area to verify that the programming succeeded.
If the programming is a failure there is a short buzz and the
swipe Card Reader LEDs lights red for three seconds.
5.3 Fingerprint Swipe Reader Configuration Cards
The Fingerprint Swipe reader configuration card allows the
creation of a configuration card, used to configure the various
Fingerprint Swipe readers such as the AY-B1663, AY-B3663, and
AY-B4663.
To Prepare Biometric Swipe Configuration Cards
1. Select the Swipe Reader tab.
2. Select the applicable Operation Mode , either Sector or
Card Serial Number (CSN) .
For Sector operation mode, define the ID Location using
the Sector Number , Block Number , and Byte Number fields.
3. Ensure that the Operations is set to Program Card .
4. From the Operation Type dropdown menu, select Program
configuration card .
5. Select the Card Type , either Mifare 1 K or Mifare 4 K .