Ross OpenGear HDC-8223A, Руководство пользователя

Страница: 22 / 80

2–6 • Installation HDC-8223A(-S) User Manual (Iss. 03)
Audio Cabling
The R2C-8223A rear module provides 3-pin audio terminal blocks with removable connectors.
Each block has locations for the positive, negative, and grounded wires of a balanced audio cable.
To cable the analog audio connections
1. Insert an analog audio wire to the designated polarity slots on the connector of the rear
module. (
Figure 2.4 )
Figure 2.4 Connector Wiring for Rear Module Input Sockets
2. Use a tweaker screwdriver to tighten the corresponding capture screw.
3. Repeat steps 1 and 2 for each wire on each connector.
4. Once the cables are wired to the connectors, install the connectors on the terminal blocks
for the rear module.
Note
— Unbalanced connections can be connected across the + and G terminals. Note that
this connection will experience a 6dB voltage gain loss. Adjust input gain for these connections
accordingly.
Rear Module Connector
Removale Phoenix Contact™ Plug
View oriented with top (screw terminals) up