Ross OpenGear HDC-8223A, Руководство пользователя

Страница: 19 / 80

HDC-8223A(-S) User Manual (Iss. 03) Installation • 2–3
Installing the HDC-8223A(-S)
This section outlines how to install a rear module and a card in an openGear frame. The same
procedure applies regardless of the rear module or card model.
Supported Rear Modules
The R2-8223A Full Rear Module or the R2C-8223A Full Rear Module can be used.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “ Installing the Card ” on page 2-4.
To install a rear module in the openGear frame
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the card installation. If there
is no Blank Plate installed, proceed to the next step.
3. Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane. ( Figure 2.1 )
Figure 2.1 Rear Module Installation in an openGear Frame (Card not shown)
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
5. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
6. Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
Screw Hole
Module Seating Slots