Ross OpenGear HDC-8223A, Руководство пользователя

Страница: 20 / 80

2–4 • Installation HDC-8223A(-S) User Manual (Iss. 03)
Installing the Card
This section outlines how to install the card in an openGear frame. If the card is to be installed in
any compatible frame other than a Ross Video product, refer to the frame manufacturer’s manual
for specific instructions.
To install the card in an openGear frame
1. Locate the Rear Module you installed in the procedure “ Installing a Rear Module ” on
page 2-3.
2.
Hold the card by the edges and carefully align the card-edges with the slots in the frame.
3.
Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module.
4.
Verify whether your label is self-adhesive by checking the back of the label for a thin,
wax sheet. You must remove this wax sheet before applying the label to the rear module
surface.
5.
Affix the supplied Rear Module Label to the BNC area of the Rear Module.
Caution
— Heat and power distribution requirements within a frame may dictate specific slot
placements of cards. Cards with many heat-producing components should be arranged to
avoid areas of excess heat build-up, particularly in frames using convectional cooling.