Ross Master Control MC1-PANEL-16, Руководство пользователя, Страница: 26 / 58

26 • Configuration MC1-PANEL-16 User Guide (v4.0)
To run in DHCP Mode
If you wish to run in DHCP mode only, set
SW1
to
UP
and
SW2
to
DOWN
.
To run in Static Mode
1. Set
SW1
to
UP
and
SW2
to
UP
.
2. Configure the new settings as outlined in the section “ Custom User Configuration via DashBoard ” on
page 26.
To verify the IP address of the MC1-PANEL-16
1. Verify that the correct IP address is reported on the MC1-PANEL-16 LCD Display.
2. Ensure that the MC1-PANEL-16 displays in the Tree View of DashBoard.
3. Verify that the information reported in the Ethernet tab is correct:
a. Select the Configuration node to display the interface in the right-half of DashBoard.
b. Select the Ethernet tab.
c. Ensure the fields in the Ethernet tab are reporting the correct settings.
Troubleshooting
If the MC1-PANEL-16 has been previously setup, but you cannot get to the IP address (or it is on the wrong subnet)
reported on the chassis display:
1. Set
SW1
to
UP
and
SW2
to
DOWN
(DHCP mode).
2. Verify that the MC1-PANEL-16 IP address is reported on the chassis display.
3. Launch DashBoard.
4. Verify that the MC1-PANEL-16 displays in the Tree View.
5. If the MC1-PANEL-16 is displayed in DashBoard:
a. Set
SW1
to
UP
and
SW2
to
UP
(Custom User mode).
b. Configure the new settings as outlined in the section “ Custom User Configuration via DashBoard ” on
page 26.
6. If you still cannot establish a connection to the MC1-PANEL-16:
a. Set
SW1
and
SW2
to one of the Preset Configurations. Refer to Table 3.1 for switch positions.
b. Proceed to the section “ Preset Configuration using the DIP Switches ” on page 27.
Custom User Configuration via DashBoard
Once communication is established with the MC1-PANEL-16, the network settings may be adjusted using the
following procedure. Note that the steps are optional, you may perform as many, or as few, as needed.

Some settings may require that you configure a DIP Switch before proceeding. Refer to the section “ Setting the
DIP Switches ” on page 20 for details.
To configure the network settings via DashBoard
1. From the Tree View , expand the node for the MC1-PANEL-16 you want to access.
2. Select the Configuration node to display the interface in the right-half of DashBoard.
3. Select the Ethernet tab.