Ross Master Control MC1-PANEL-16, Руководство пользователя, Страница: 20 / 58

20 • Physical Installation MC1-PANEL-16 User Guide (v4.0)
Figure 3.2 MC1-PANEL-16 — Ethernet Connection
Setting the DIP Switches
This section briefly summarizes the DIP Switch settings on the MC1-PANEL-16. Refer to Figure 3.2 for the
locations. Note that Figure 3.3 shows the DIP Switches in the UP position.
Figure 3.3 DIP Switches — UP Position
SW1, SW2 — IP Address Setup
SW1
and
SW2
are used in conjunction with the DashBoard menus to set the IP Address of the MC1-PANEL-16.
Refer to Table 3.1 and the card labeling for DIP Switch positions.
SW3
SW3
is not implemented at this time and should be left in the default UP position.
Table 3.1 SW1 and SW2 Positions
SW1 SW2
Controlled via
DashBoard Descriptions
UP UP

Custom User Configuration via DashBoard
The MC1-PANEL-16 network settings can be set by the
user from DashBoard using the
Ethernet tab. However,
DHCP Mode is assumed until the user changes the
settings in DashBoard. (Recommended)
This is the default positions.
UP DOWN
Automatic Configuration using DHCP
The MC1-PANEL-16 network settings are
automatically assigned (DHCP Mode).
DOWN UP
Preset Configuration 1 using DIP switch(es)
The MC1-PANEL-16 IP Address is set to 192.168.2.10
and the Subnet Mask is set to 255.255.255.0.
DOWN DOWN
Preset Configuration 2 using DIP switch(es)
The MC1-PANEL-16 IP Address is set to 10.1.2.10 and
the Subnet Mask is set to 255.255.255.0.
PMC LINK
1
2
ETHERNET
1
2 SD
MODE
PS 2 PS 1
To Ethernet Network