Rose Point MDS-51, Руководство по установке, Страница: 8 / 31

Rose Point Radar Installation Guide 5
Installing the Scanner Unit
When you have decided upon the place of installation, install the scanner unit. If a mounting base like
the one shown below is available, it may be easier to install the scanner. If such a mount base is not
available in your ship, you may install the scanner directly to the roof, etc. In such a case, pay attention
to the water drain tube located at the bottom of the scanner unit during installation.
Note:
• When the radar mast or mounting bracket has a curvature of more than 2mm, repair it or use spacers.
Mounting Base
Referring to “Hole positions for mounting scanner”, open holes in diameter of 12 mm (0.47 in.) at five
locations in the mount base and use these holes to fix the scanner unit to the mount base with
hexagonal bolts. (Use the template included with this manual.) The bolts included with your radar
equipment will suffice for mount base thickness of 9 to 14 mm (0.35 to 0.55 in.). If the mount base is
thicker or thinner than this, prepare bolts listed in “Bolts for Mounting Scanner Unit”.
RB715A Radome scanner RB716A/717A/718A Open Scanner
Hole positions for mounting