SERVICE INFORMATION
Maintenance and repair
The unit does not contain any user-serviceable parts inside. Any
malfunction of the unit should be reported to a factory-authorized repair
center for service. Any discrepancies in the operation of the unit according
to this manual should be reported to the Rose Electronics Technical
Support Department.
Reset to factory default
To reset the UltraView to its factory default settings hold the – switch in at
power up. Keep it pressed in until the unit switches to the last port on the
unit, port 4 (on a 4-port unit), port 8 (on an 8-port unit), and so on. If the
monitor is connected, various diagnostic messages will appear. If you
release the switch quickly after turning the power on, the memory will not be
reset and you can observe the diagnostic messages. The messages
indicate the firmware revision levels and on-board diagnostic test results.
39
ULTRAVIEW INSTALLATION AND OPERATION MANUAL
Содержание UltraView
Страница 2: ......
Страница 50: ......
Страница 51: ......
Страница 52: ...ELECTRONICS 10707 STANCLIFF ROAD n HOUSTON TEXAS 77099 n TEL 281 933 7673 ...