Rosco Maximizer 2B, Инструкция по эксплуатации, обслуживанию и ремонту

Страница: 59 / 362

5
Rosco Maximizer 2B Asphalt Distributor 5-17
Component Location
Table 5-5. Run Screen
ITEM NO CONTROL NAME FUNCTION
1 Mode Selection Screen (Button 1) Calls up the Mode Selection Screen to select and set 1 of 8 modes
of distributor operation . See Figure 5-6 .
2 AUTO / MANUAL
Selection (Button 2) Operator can select Auto or Manual Control of the distributor .
Auto Control - Asphalt Pump speed is automatically controlled through
the Plus 1 Controller using a PID rhythm . The set application rate is
automatically held constant regardless of changes in spraybar width or
vehicle speed . Auto control can be activated when operating the distributor
in Spray or Bar Circulate mode . All other modes of operation will default to
Manual control with the exception of Auto Cleanout mode . Auto Cleanout
mode automatically sets the speed and direction of the Asphalt Pump
according to a programmed sequence in the Plus 1 Controller .
Manual Control - Operator has complete control of the Asphalt Pump speed
and direction through the speed pots on the In-Cab Control Box or the Right
Rear Fender Control . The operator can select one or the other by toggling
the Front or Rear priority selection (Button 3) . The Run Screen display
indicates the asphalt flow rate so the operator can judge the Asphalt Pump
speed adjustments that need to be made .
3 FRONT / REAR Control
Priority Selection (Button 3) Defines either In-Cab Control or Rear Fender Control of the
spraybar hydraulic functions and asphalt pump speed/direction .
4 Setup Parameters (Button 4) Defines operating parameters.
5 Inactive Button (Button 5) is inactive -Not used
6 Memory (1 of 12) (Button 6) Pre defined distributor application rates stored in memory.
7 Application Rate (Button 7) Sets the application rate (gal/sq .yd .) .
8 Error Fault Screen (Button 8) Used for help troubleshooting the distributor when an error
occurs . Used as a diagnostic tool if a problem or breakdown should occur .
9 Flow Rate Dial gpm
(Lpm) Real time measurement of asphalt flowing through the asphalt pump.
10 Distributor Speed Dial
fpm (mpm) Real time measurement of distributor ground speed .
11 Asphalt Tank
Temperature °F (°C) Real time measurement of asphalt temperature in the tank .
12 Current Mode Indicator Current Distributor Operating Mode .
13 Appl . Rate gal/sq . yd . (L/
sq .m) Display of set application rate .
14 Bar Length ft .-in . (m-cm) Real time display showing the spray width from 4” to 24’ in 4” increments
(10cm - 7 .3m in 10cm increments) .
Return to
Last Viewed
Return to
Thumb Index