Rosco Maximizer 2B, Инструкция по эксплуатации, обслуживанию и ремонту

Страница: 32 / 362

4-6
Rosco Maximizer 2B Asphalt Distributor
Specifications
Table 4-1. Tank Specification Table
ITEM SPECIFICATION
Tank Capacity 1000 U .S . gallons (3,785 L) to 4000 U .S . gallons (15,142 L) with overage for expansion .
Tank Meets all applicable Federal DOT tank regulations. Elliptical shape. 10 gauge (3 mm)
shell and 7 gauge (4.5 mm) flat heads, flanged reinforced and welded to shell inside & and
outside of tank . All seams electrically welded .
Shell 10 gauge, elliptical shape shell. 7 gauge flat heads, flange reinforced and electrically
welded to shell inside and outside of tank .
Thermometers Armored pencil inspector’s type 50° F to 500° F (10° C to 260° C) and 5 inch (127 mm) dial
type 50° F to 500° F (10° C to 260° C) mounted on front left side of tank in pipe well. Tank
temperature sensor, located at rear of tank, displayed on color display of in-cab controller .
Full Surge Plates 10 gauge (3 mm) steel with staggered openings .
Insulation 2 inch (51 mm) rock wool with spacers to prevent compression, and clips to secure
position of insulation. Weatherproof aluminum jacket.
Top Opening 22 inch (558 mm) diameter with weather tight and safety relieving cover . Inside splash
guards, 3 inch (76 mm) diameter, steel measuring stick, basket type strainer, overflow pipe,
and tank vent .
Sump 8 inch (203 mm) diameter at rear of tank with 4 inch (102 mm) clean-cut plug . Suction line
from pump includes tank cut-off valve .
Heating System Double flue with 8 inch (203 mm) inside diameter tubing.
Exhaust Stack Stainless steel with rain cover .
Burners Dual diesel fired burner with electronic ignition and heat limit controls. Dual, U-type high-
temperature flue pipe running the length of the tank.
Asphalt Pump Viking 400 GPM (1514 LPM) capacity, rotary gear pump with built in relief valve for safety .
Located at rear of unit with suction piping to tank sump. Driven by low-speed, high-torque,
fixed displacement hydraulic motor.
Distributing Lines High-temperature, flexible metal hoses.
Clean Out Connection to asphalt pump for clean-out of pump and piping. 25 gallon (94.6 L) flush tank.
Spray System 12 foot (3 .7 m) full circulating bar with two 4 foot (1 .2 m) center sections and two 2 foot (0 .6
m) cab control folding wings . Power lift and shift of spraybar . Exclusive two-way safety
breakaway system provides protection against damage when an obstruction is hit while
traveling either forward or reverse .
Nozzles and Valves Brass, slotted nozzles, with non-clogging, quick-disconnect valves. Allows the operator to
change spray widths in 4 inch (10 .16 cm) increments .
Specification Tables
The specifications provided in this section are
applicable to the Rosco Maximizer 2B Asphalt
Distributor .
Included in this section are dimensions, performance,
and torque values for both metric and standard inch
fasteners .
Replace original equipment only with
LeeBoy approved components.
Return to
Last Viewed
Return to
Thumb Index