Rosco Maximizer 2B, Инструкция по эксплуатации, обслуживанию и ремонту

Страница: 121 / 362

7
Rosco Maximizer 2B Asphalt Distributor 7-5
Maintenance
Grease For Other Components
Use an SAE multi-purpose high temperature grease
with extreme pressure (EP) performance or a SAE multi-
purpose lithium base grease .
Hydraulic Oil
When adding or changing the hydraulic oil, refer to
Table 7-2 Hydraulic Fluids Chart . Fluids that are
not equal to those listed could result in substandard
performance or failure of components .
Clean-out Solvent
Any commercially available cleaning solvent or release
agent can be used to flush out the system. If the circuit
is connected to the burner fuel supply, comply with the
burner fuel specification when filling the tank.
Do not use Terpene Hydrocarbon or
equivalent to clean out the spraybar It destroys the
Viton seals
Truck Systems
Follow recommendations in the truck Operator’s
Manual for fuel, lubricating oils, coolants and lubricating
greases . Consult with truck manual for system
capacities and servicing frequencies .
Tank Components
Tank Sump
The Maximizer 2B is designed with a sump in the bottom
of the tank where the asphalt gathers and is drawn into
the pump . The tank is equipped with a removable plug
on the bottom for draining condensation from the tank
and cleaning the sump . When opening the sump, follow
this procedure:
1 . If it is necessary to open the sump during the work
day, be sure the tank is cool to the touch .
2 . Stop the engine, place all controls in neutral, set the
park brake, remove ignition key and make sure tank
is empty before starting by following the Unloading
procedure (see
Unloading Mode in Section 6) .
Always wear protective clothing,
gloves and a face shield Contact with hot asphalt
can cause severe burns
1 . Lubricate asphalt pump bearings, 2 locations
( Figure 7-1 ) every 3 hours or twice daily .
HYDRAULIC
MOTOR
Asphalt Pump
Figure 7-1
2 . Lubricate asphalt circuit valve stems, one location
on the 3-Way valve and the 2-Way valve every 3
hours or twice daily .
Figure 7-2 shows the 3-Way
valve .
Lubricate the points described above
at the end of the day to prevent seizing or setting up
over night
GREASE ZERK
Asphalt Pump Valve
Figure 7-2
Return to
Last Viewed
Return to
Thumb Index