ROPA KS 475, Перевод оригинального руководства по эксплуатации

Страница: 72 / 110

Operation
Angular gear
6.9 Angular gear
The illustration shows KS 475
(1) Protective cap
(2) Angular gear
(3) Guard cone
The angular gear ( 2 ) is flanged directly to the cardan shaft, which is connected to the
tractor PTO shaft drive and transfers the tractor engine power via another cardan shaft
on the belt drive to the topper shaft of the machine. The angular gear is located at the
top centre of the machine.
On the KS 475, the protective cap (
1 ) and guard cone ( 3 ) must be installed, depending
on the attachment of the machine to the tractor, i.e. front or rear attachment.
On the KS 490, rotate the gear to connect the machine if the machine is to be
attached to the front of the tractor.
ADVICE
The highest allowed angular gear input speed to the machine drive may not be
exceeded at any time – not even for a short time. The maximum speed depends on
the installed V-belt transmission ratio.
Maximum speed: 540 rpm, 750 rpm or 1,000 rpm
72 / 110