Roland EGX-350, Руководство пользователя

Страница: 74 / 124

72
Chapter 4 Engraving
4-7 Cutter Installation Method 4 (End mill)

Install the collet with the attached
end mill.
Loosely tighten the collet with end
mill.
Insert the collet with end mill into the spindle unit
from below, then, while holding the spindle unit
immobile with a wrench, tighten loosely.
Fully tighten the collet with end
mill.
Using two wrenches, tighten the collet fully.
The appropriate tightening torque is 3.2 N-m
(32kgf-cm).
2.
Set the lock lever.
Set the lock lever at the position.
The spindle head is secured in place.

P. 82, “The Position of the Lock Lever”
Wrench
Spindle unit
Collet with
end mill
Wrench
Wrench
Lock lever
Lift up.