Roland EGX-350, Руководство пользователя

Страница: 65 / 124

63
Chapter 4 Engraving
4-5 Cutter Installation Method 2 (No Nose Unit)

Install the solid collet.
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit from
below, then, while holding the spindle unit im-
mobile with a wrench, tighten loosely.
Use an appropriate solid collet for the
cutter’s diameter.
Fully tighten the solid collet.
Using two wrenches, tighten the solid collet fully.
The appropriate tightening torque is 3.2 N-m
(32kgf-cm) .
2.
Set the lock lever.
Set the lock lever at the position.
The spindle head is secured in place.

P. 82, “The Position of the Lock Lever”
Wrench
Spindle unit
Solid collet
Wrench
Wrench
Lock lever
Lift up.