Rohde & Schwarz FSMR series, Начало работы

Страница: 29 / 131

Getting Started with the Instrument R&S FSMR
1313.9617.12 1.18 E-2
Connecting the Instrument to the AC Supply
The R&S FSMR is equipped with an AC voltage selection feature and will automatically adapt itself to
the applied AC voltage (range: 100 to 240 V AC, 40 to 400 Hz). External voltage selection or adaptation
of the fuses are not necessary. The AC power connector is located on the rear panel (see below).
o I
Power connector
Connect the instrument to the AC power source using the AC
power cable delivered with the instrument.
As the instrument is designed according to the regulations for
safety class EN61010, it must be connected to a power outlet
with earthing contact.
Switching the Instrument On/Off
Do not power down during booting.
Such a switch-off may lead to corruption of the hard disk files
AC power switch on the rear panel
Power switch
I 0
Power connector
Power switch
Position I = ON
In the I position, the instrument is in standby mode or in
operation, depending on the position of the ON/STANDBY
key at the front of the instrument
.
Note: The AC power switc
h
may remain ON continuously.
Switching to OFF is only required when the instrument
must be completely removed from the AC power source.
Position O = OFF
The 0 position implies an all-pole disconnection of the
instrument from the AC power source.
ON/STANDBY switch on the front panel
ON STANDBY
Standby switch
The ON/STANDBY switch activates two different operating
modes indicated by coloured LEDs:
Operation ON - ON/STANDBY is depressed
The green LED (ON) is illuminated. The instrument is
ready for operation. All modules within the instrument are
supplied with power.
Shock hazard
In standby mode, the AC power voltage is present within the instrument
STANDBY - ON/STANDBY switch is not pressed.
The yellow LED (STANDBY) is illuminated. Only the
power supply is supplied with power and the quartz oven
is maintained at normal operating temperature.