Rohde & Schwarz CTS30, Руководство по эксплуатации, Страница: 122 / 217

Windows

Application CTSgo CTS-K6
1079.2001.01 70 E-3
The following RX measurements are available:
•
BER (Bit Error Rate)
•
FER (Frame Error Rate)
The RF output level of the CTS for these measurements is to be determined in the RF Level field of
RX Measurements. Besides, the number of frames to be sent is determined.
The following TX measurements are available:
•
NTP (Normal Transmit Power)
•
Power ramp (Template)
•
Graphics burst display in the appendix to the measurement report
•
Frequency offset
•
B-field modulation
•
Graphics display of the modulation in the appendix to the measurement report
•
Frequency drift
•
Time accuracy
•
Jitter
•
Acoustic echo test
For these measurements, the RF output level of the CTS is to be entered in the RF Level field of TX
Measurements. Besides, the number of bursts to be sent is determined for the power and modulation
measurement or the number of bursts to be sent for the timing measurement.
Note:
This command can only be called if FP test set 1 is activated for the test.
7.5.5 FP Test Set 2
You can determine the tests to be performed for the Traffic Bearer. For details refer to the description
of FP Test set 1.
Note:
This command can only be called if FP Test set 2 is activated for the test.
7.5.6 FP Test Set 3
You can determine the tests to be performed for the Traffic Bearer. For more details refer to the
description of FP test set 1.
Note:
This command can only be called if FP test set 3 is activated for the test.
7.5.7 FP Test Set 4
You can determine the tests to be performed for the Traffic Bearer. For more details refer to the
description of FP test set 1.
Note:
This command can only be called if FP test set 4 is activated for the test.