Rockwell RK2515K2, Руководство пользователя

Страница: 10 / 28

12V 3IN1 DRILL / SCREWDRIVER / IMPACT DRIVER ENG
10
driving, apply a small quantity of liquid soap or
similar to the screw threads to ease insertion.
Impact driver operation
slide the function mode selection switch (9) to mark “ ”.
The adjusting ring can be aligned in any torque levels for this
operation.
7. DISPoSAL oF AN EXHAuSTED BATTERY PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains Lithium batteries. Consult your local
waste authority for information regarding available recycling
and/or disposal options. discharge your battery pack by
operating your tool, then remove the battery pack from the
tool housing and cover the battery pack connections with
heavy-duty adhesive tape to prevent short circuit and energy
discharge. do not attempt to open or remove any of the
components.
MAINTENANCE
your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never
use water or chemical cleaners to clean your power tool.
Wipe clean with a dry cloth. always store your power tool
in a dry place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you may see
sparks through the ventilation slots. This is normal and will
not damage your power tool.
TRouBLESHooTING
Problem Cause Action
The screwdriving guide,drywall screw
setter, magnetic bit holder, keyless
chuck or right angle drill attachment
becomes damaged or stuck.
The accessories are used in impact
mode.
do not use the accessories with the
impact driver mode setting.
Right angle drill attachment becomes
damaged.
Right angle drill attachment is used
with too much torque.
use different drill setting with
torque less than 98 in-lbs (11N
•
m).
drill bits do not fit in to the chuck or
collet.
The chosen drill bits are not the
appropriate size for the 3RiLL
TM
.
use 1/4˝(6.35 mm) hex shank drill
bits.
Cannot switch from impact mode to
drill mode.
The switching mechanism is not
aligned.
Pull the 3RiLL
TM
trigger and let it
run briefly before switching drilling
modes.
3RiLL
TM
LEd light flashes. 3RiLL
TM
has low power. Battery needs to be charged.