Rockwell RK2515K2, Руководство пользователя

Страница: 8 / 28

12V 3IN1 DRILL / SCREWDRIVER / IMPACT DRIVER ENG
8
SYMBoLS TECHNICAL DATA
Voltage 12 V
No-load
speed
screwdriver mode 0-600/min
drill mode (Lo-hi)
0-600/
0-2200/min
impact driver mode 0-2200/min
impact rate 0-3000 bpm
Max torque
impact driver mode 800in-lbs(90 N
•
m)
drill mode 130 in-lbs (15 N
•
m)
Number of clutch positions 22
drilling
capacity
Wood 3/4˝(19mm)
steel 5/16˝(8 mm)
Chuck type 1/4˝(6.35 mm)hex
Charging time 30 min
Machine weight 2.7 lbs(1.2 kg)
oPERATING INSTRuCTIoNS
NoTE:
Before using the tool, read the instruction
book carefully.
CHARGING
A) BATTERY CHARGING
The battery charger supplied is matched to the Li-ion
battery installed in the machine. do not use another battery
charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off by
means of a protective circuit: The chuck no longer rotates.
in a warm environment or after heavy use, the battery pack
may become too hot to permit charging. allow time for the
battery to cool down before recharging.
When the battery is charged for the first time and
after prolonged storage, the battery will only accept
approximately 60% charge. however, after several charge
and discharge cycles the battery will accept a 100% charge.
B) To REMoVE oR INSTALL BATTERY PACK (SEE A)
depress the battery pack release button to release and slide
the battery pack out from your tool. after recharge, slide it
back into your tool. a simple push and slight pressure will
be sufficient.
oPERATIoN
1. INSTALLING oR REMoVING A BIT HoLDER, SoCKET
oR SCREWDRIVER BIT (SEE B)
To install the desired bit, pull the collet locking sleeve (7)
forward and insert the desired bit into the sleeve as far as it
To reduce the risk of injury, user must read
instruction manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
indoor use only
do not expose to rain or water
do not burn
direct current