MHP GJK 36 Series, Инструкция по сборке, Страница: 1 / 5

GJK Assembly Instructions
Grill Assembly
Instructions
•
The GJK 36” Series Grill Model is almost
completely factory assembled.
•
Assembly is required for: The locking cast-
ers, side shelves, condiment holders, doors,
hole plugs, grates and briquets.
•
Please consult the Owner’s manual for addi-
tional pertinent information regarding im-
portant general safety rules, maintenance,
troubleshooting, etc.
•
Leak test all gas connections before using.
•
Caution: Combustible material should never
be within 24 inches of the top, bottom, back
or sides of your MHP Gas Barbecue Grill.
Step 1: Locking Casters
(See Fig. 1)
The locking casters are packed with the side shelves.
Lift one end of the grill about 12 inches and block it so
it won’t fall. Simply push the casters up into the corner
pocket brackets until they bottom out. Some resis-
tance will be felt so the casters may have to be tapped
up with a block of wood. They should also bottom out
when the grill is set back down. The casters are
locked when the foot tab is in the down position.
Step 4: Attaching the Doors (
Fig. 3)
The doors simply drop onto the hinge pins. Hold the door
in the open position (straight out from the grill front) and
carefully match the hinge pins to the door hinges and
push down.
The bottom catch is magnetic, the top catch is a me-
chanical pull catch. On the inside of the right hand door
install the wire condiment holder using two (2) 10-24 x
½” bolts and nuts. Tuck the horizontal wire hooks behind
the door edge.
Complete View of GJK Grill
Step 2: Side Shelves
(See Fig. 2)
The side shelves are attached to the main cart with four
¼ - 20 X ½" bolts and split washers. Simply install one
(1) upper bolt (w/washer) loosely and let the shelf hang.
Then lift, pivoting the shelf while the remaining bolts and
washers are put in and tightened.
Step 3: Condiment Holders
See Fig. 2)
Condiment Holders are attached to the front of the side
shelves using the two 10-24 x ½" Stainless Steel
Carriage Bolts and Kep nuts for each holder.
Fig. 2