Robland HX TZ, Руководство пользователя

Страница: 30 / 98

HX SERIES V0212
29
–
English
–
Deutsch
Fig.25
Planer fence
(fig. 26,27)
1 The planer can be adjusted according to the width of the work piece after unlocking the handle
(1)
2 After unlocking the clamping handle (2) the fence can be set at 45° and 90°.
The adjustment screw for position 90° is at the bottom of the clamping plate.
The adjustment screw for position 45° is at the upper side of the clamping plate.
Fig.26
Planer protection
(fig. 27, 28 en 29)
The planer protection is composed of an aluminium protection bridge which can be adjusted in height
parallel to the planer arbor and tables at 100 mm maximum. For surface planing the bridge (1) has
to be lowered by means of the adjustment knob (fig. 28.1). This position is not inflexible. Thanks to
the flatted, bulged shape of the bridge, the work piece can be pushed over the planer in one fluent
movement. That way, tracks of retaking are avoided. Move the bridge sideways by loosening the knob
(fig. 28.1
This protection has to be set in place for every operation on the planer.
Set the height with the adjustment knob, the work piece is guided along the planer fence. First check
the work piece for straightness and always put the work piece with the concave down. Then set the
chip thickness by adjusting the in feed table. For planing the narrow side of a work piece the protection
3
1
2
1
3
2
1