Robland HX TZ, Руководство пользователя

Страница: 24 / 98

HX SERIES V0212
23
–
English
–
Deutsch
Mitre fence
(fig. 17)
The mitre fence is mounted on to the sliding table as shown on the picture. The flat nut in the groove of
the table is factory set at 90°.
For tilting the mitre fence, loosen the vertical post (1) of the wood clamp and the Kipp handle (3) and
move the fence to the wanted angle.
The reading is done at the back of the support plate of the guide itself. Loosen both Kipp handles (2)
for moving the fence as close as possible to the saw blade.
Make sure that all handles are fastened after the adjustment of the fence.
To remove the fence from the table: loosen the vertical post (1) of the wood clamp and the Kipp handle
(3) and remove it.
Fig.17
Spindle
Mounting the tools on the spindle (fig.18)
1 Set the brake release switch of the selector switch on in order to free the brake and turn the
spindle free by hand and set the Allen key on the countersunk Allen bolt on top of the spindle
arbor (1)
2 Push the locking lever (2) to the right and, at the same time, manually turn the spindle arbor (3)
until the lower locking pin locks into the hole in the spindle.
3 Now loosen the clamp screw on top of the arbor with the Allen Key.
4 Always mount the spindle as low as possible on the arbor, so the bearing isn’t overloaded.
5 Mount the correct number of spindle rings and tighten the screw, on top of the arbor.
6 When the lever (2) is released, the locking of the spindle arbour is automatically disengaged.
7 Always lock the position of the spindle height by locking the handle (3) behind the handwheel.
Fig.18
2
3
1
1
2
3
4