Robland HX TZ, Руководство пользователя

Страница: 18 / 98

HX SERIES V0212
17
–
English
–
Deutsch
Mounting of the saw blade
(fig.7)
1 Slide away the table.
2 Open the lower saw blade cover plate (1).
3 Raise the saw blade to the highest point.
4 Now put the locating pin (3) in the saw table to block the saw arbor.
5 Tighten the saw nut with the hookspanner (4). Warning: left hand threaded saw arbor!
6 Do not forget to remove the pin which holds the saw arbor in place while tightening the nut.
Fig.7
Adjusting the riving knife
(fig. 8)
The saw is equipped with a riving knife suitable for saw blade diameters of 200 and 250 mm.
Always set the riving knife (1) close to the saw blade so that the gap never exceeds 4 mm. The riving
knife can be set in line with the saw blade by using the bolt (1) and the 3 adjustment screws (2). The
bolt only moves the riving knife longitudinally. The 3 adjustment screws (2) the riving aligns with the
saw blade.
Fig.8
the bolt
adjustment screws