Robland HX TZ, Руководство пользователя

Страница: 22 / 98

HX SERIES V0212
21
–
English
–
Deutsch
Mounting the cross cut table
(fig. 13)
The cross cut table can be mounted onto the machine by hooking it on to the side of the sliding
table. The handle (1) locks the outrigger table on to the sliding table. The outrigger table is only to be
positioned at the rear side of the sliding table.
Fig.13
Mounting the cross-cut fence
(fig. 14)
The cross-cut fence has 2 pins that are to be located in the holes on the outrigger table.
To put the fence in position, locate the pins of the fence in the holes.
Put the 2 locking knobs (1) to fix the cross-cut fence. The fence is set at 90° in the factory, but when the
90° shouldn’t be correct anymore, it can be adjusted as follows:
Loosen the 2 locking handles (1) and the bolt (2) below the cross cut table, to loosen the 90° fence
stop.
Turn the adjustment bolt (3) to the left or to the right, to move the fence and to open or close the 90°
angle in relation to the saw blade. After this adjustment, tighten the bolt (2) and locking knobs (1). The
fence can be used in both positions, at the front or the back of the cross cut table.
Fig.14
1
1