Robland HX TZ, Руководство пользователя

Страница: 31 / 98

30
V0212 HX SERIES
–
English
–
Deutsch
bridge has to be lowered to the table and has to be set according to the work piece width. Set the
protection bridge with a minimal opening to the work piece to ensure maximum cover and safety. To
clear the planer protection from the tables, unlock the handle and swing the complete protection to the
back.
Fig.27 Fig.28
Fig.29
Thicknesser adjustment (fig. 30)
1 The rise and fall of the thicknesser table can be adjusted with the handwheel (1). One turn of this
hand wheel equals 4 mm.
2 After height setting the thicknesser table has to be locked with the lever (2) situated behind the
hand wheel, the height of the table can be read at the scale (3).
3 When, after intensive use of the locking lever (2), it is no longer possible to lock it, take off the nut
which holds the lever and remove the lever. Then turn the lever 1/6 turn clockwise and put it back
on again. Put the nut back on and tighten it again.
4 The table height cutting depth setting has to be adjusted in such a way that there is always 1 mm
minimum clearance between the top of the wood and the connection bar between the bearing
houses.
5 Always ensure that the anti-kickback protection fingers are kept clean and hang down freely in
position under their own height.
6 The feeding mechanism can be engaged by unlocking the lever (4) and pulling it up. The feed
through speed is 7 m/min.
7 In case of overloading of the feeding mechanism the feed rollers must be disengaged
immediately by pushing down lever (4). Most likely the cutting depth setting is too big. Lower the
table ½ a turn with the hand wheel and start all over again.
1
1