Roberts Gorden Energytube EM-115, Инструкция по установке, эксплуатации и обслуживанию

Страница: 45 / 82

SECTION 10: W
IRING
39 of 71
SECTION 10: WIRING
Heater m u st be gro u nded in accordance w ith
applicable codes: United States: refer to National
Electrical Code ® NFPA 70 - latest re v ision
Canada: refer to Canadian Electrical Code, CSA
C22.1 Part I - latest re
v ision.
If any of the original internal w iring m u st be replaced,
it m u st be replaced w ith w iring materials ha v ing a
temperat u re rating of at least 105°C and 600 Volts.
10.1 Heater Wirin g for use with Brooder
Controller
The heater w ill a u tomatically mod u late w hen
connected to an o u tp u t relay on a brooder controller.
10.1.1 Line Volta g e Power Wirin g
All b u rners are po w ered by a circ u it(s) separate from
the brooder controller o u tp u ts. The b u rners m u st
ha v e an u ninterr u pted 120 V, 60 Hz, 1 Ø po w er
s u pply.
FIGURE 19: Line Volta g e Power Wirin g
DANGER
Electrical Shock Hazard
Disconnect electric before service.
Heater must be properly grounded.
Failure to follow these instructions can result
in death or electrical shock.
Gnd.
120 V-60 Hz
Supply Circuit
H
N
H
N
L1
L2
Gnd.
Gnd.
Burner 2
Burner 3
Gnd.
Burner 1
H
N
NOTE: The b u rners m u st ha v e an uninterrupted 120 V, 60 Hz, 1 Ø po w er s u pply.
All b u rners are po w ered by a circ u it(s) seperate from the brooder controller o u tp u ts.